KIT-VINTAGE AIR CONDITIONING CONVERSION-GEN IV-SMALL BLOCK-WITHOUT FACTORY AIR-68-72 (#E17642)

1968-1972 C3 Corvette Vintage Air Gen IV System - Small Block Without Factory Air Conditioning.

For 1968-72 Corvettes Not Equipped With Factory Air Conditioning
Electronic Servo Motor Controls-No Cables Or Capillary Tube To Route
Separate High Capacity Heat & Cooling Coils
Mounts Completely Behind Dash
Air Conditioning Exists Through Original Dash Vents
Steel Firewall Cover Plate
Dehumidified Defrost With Infinite Dash/Floor Blend
Infinite Dash/Floor Blend
Adapts To Original "Thumb Wheel" Type Controls

All new design specifically for 1968-72 Corvette models. New separate heater and cooling coils and high volume blower give you OEM quality comfort, provide infinite dash and floor blending and retains the factory look inside your vehicle. Factory "wheel type" console controls are used. Sure Fit systems mount to existing holes in dash and firewall in most cases.

Chevy Corvette mechanical short style water pumps measure 5-5/8” high from the shaft down with the pilot shaft diameter measuring 5/8". Long style Chevy Corvette water pumps measure 7” high from the shaft down, and the pilot shaft diameter was 5/8" as well. Do not mix and match pulleys from short and long water pump engines because this will cause pulley misalignment. An easy way to find out what style you have while your pump is still installed on the engine is to try to stick your hand between the water pump and timing chain cover. If you can slip your fingers in-between you have a long, if not you have a short.

Fits: 1968, 1969, 1970, 1971, 1972 Corvette Small Block without Factory A/C